IncusOS Unreachable After Install

[RossMadness]

Hello there.

I just installed IncusOS on a SFF computer that I have previously used for IncusOS before switching to Proxmox to test some features. I have performed a fresh install of IncusOS twice using new images built from the web customizer tool, and both times the system boots, says the system is ready and then is not reachable at the IP address. I can ping the IP address just fine, but if I try to go to the web UI in a browser it says “refused to connect”.

I tried to look for another issue similar to this, and this one sounds like the same behavior, but it was for an existing IncusOS install.

IncusOS booted and says “System is ready”, but remote Incus API refuses connections after power-off

I’m running IncusOS on a homelab server. It used to work, but after powering off the server and booting it again, the Incus client can no longer connect. The machine appears to boot successfully. On the attached display/logs I see Incus start normally, including: “System is ready” together with the Incus version. The server network interface eno4 has: IPv4: 10.155.0.23, IPv6: 2607:f598:dc00:767:3eec:efff:fe78:23bf. From my Mac/client machine, the host is reachable: ping 10.155.0.23 works with …

Any suggestions on how to start troubelshooting this would be appreciated.

[stgraber (Stéphane Graber)]

Any chance you can share the full screen output on the system?
Also just to confirm, you’re trying to access it on port 8443?

[RossMadness]

I’m ashamed to say it, but apparently the first time I typed the address in the browser I mistyped 8443 and then the browser autofill kept inserting the mistyped port number on each connection attempt after that. I didn’t notice until you pointed it out.

The system is up and working correctly. Sorry about the trouble.